Question

A network engineer needs an EEM applet on a core switch that automatically bounces GigabitEthernet1/0/24 whenever the interface goes into an err-disabled state. The engineer wants the applet to trigger off the syslog message that is generated at that moment and then issue a shutdown followed by a no shutdown on the interface. Which EEM configuration correctly accomplishes this?

Accepted Answer

event manager applet RECOVER / event syslog pattern "%PM-4-ERR_DISABLE.*Gi1/0/24" / action 1.0 cli command "enable" / action 2.0 cli command "configure terminal" / action 3.0 cli command "interface Gi1/0/24" / action 4.0 cli command "shutdown" / action 5.0 cli command "no shutdown"

Answer

event manager applet RECOVER / event timer watchdog time 60 / action 1.0 cli command "interface Gi1/0/24" / action 2.0 cli command "shutdown" / action 3.0 cli command "no shutdown"

Answer

event manager applet RECOVER / event snmp oid 1.3.6.1.2.1.2.2.1.7 get-type exact entry-op eq entry-val 2 / action 1.0 cli command "interface Gi1/0/24" / action 2.0 cli command "no shutdown"

Answer

event manager applet RECOVER / event cli pattern "shutdown" sync yes / action 1.0 cli command "interface Gi1/0/24" / action 2.0 cli command "no shutdown"